September 3, 2022
Description
This figure is meant to represent the traditional Iron Falcon RPG orcs, and honestly it's a terrible job of hack-and-paste with lots of little ugly bits. It's a combination of figures from two other designers, mz4250 (most of the figure) and MojoBob (the pig snout and shield), but they are in no way responsible for my terrible job of reassembling their models.
The scale of the figure is roughly 30mm, to match other figures I use in my games and share here. And of course, like my other figures it stands on my Two Cent Base.
MojoBob's Pig-Faced Orc can be found here: https://www.thingiverse.com/thing:5173812
The primary figure I used from mz4250's collection is the Half Orc Warrior
found here: https://www.thingiverse.com/thing:1012849
My Two Cent Base is here: https://www.thingiverse.com/thing:5200950
Without these creators sharing their work, this project would have been impossible (instead of just inadvisable).
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
75%
Filament: Inland PLA Plus Marble
Notes:
I recommend slicing with Cura and using tree supports; it's a lot easier to clean up the model if you do it this way. If you tip it back 45 degrees for printing, you'll probably need to turn on rafts to make the base print properly.
License:
Creative Commons — Attribution — Share Alike
Solomoriah
