Nose cone beauty mod for Hi-Point 9mm/30SC rifle

This is a nose cone (barrel shroud) modification for the Hi-Point 995TS 9mm Luger pistol-caliber carbine rifle.  It may fit the other Hi-Point rifle calibers, please comment if you find that it will.  The front picatinny rail must be removed for this nose cone to fit over the end of the plastic body and barrel cover on the front of the rifle.  See pictures for the exact configuration.  Note that this is a cosmetic change and does not actually modify the length of barrel, cartridge handling, or firing mechanism of the firearm.

Note that the pictures are of a print with larger mounting holes that are too low, now there is a small hole on the bottom, and the side mounting holes are smaller and higher up on the fitting.  Use one to three small screws to SECURELY fasten the shroud to the rifle.  It WILL come loose if you don't fasten it well.

BEWARE that the part MUST NOT contact the barrel as the soft meltable 3D-printed plastic is not like the high-temperature tolerant plastic body of the rifle, and if it touches the metal rifle barrel, after a few shots will MELT, SMOKE, CATCH FIRE, and (worst of all) be STINKY, so attach it to the rifle securely and ensure adequate clearance.  The gun barrel can be thousands of degrees, but 3D plastic is molten at a few hundred degrees, so keep them apart!  Everybody OK!

Addendumb:
* this also works on the Hi-Point 3095TS chambered in 30 Super Carry, and may work with others, I suspect the 380 will work
* added model with a cutout for the sling bolt