May 8, 2022
Description
I wanted to use my BOSCH Series 6 cordless vacuum cleaner to clean my car. For that reason I made this flat nozzle, to reach all the thight areas between the seats.
The model can be printed upright w/o any support material. It was printed it in PLA at 0.3 mm layer height.
I would rocommend to start the print and stop it after about 15 - 20 minutes to test fit the part on your vaccum cleaner, before printig the etire part. If necessary, scale the model in your Slicer in 1% increments to get the right size. The nozzle should stay on the vacuum cleaner just by sliding it on by hand.
Have fun an keep your car clean ;)
License:
Creative Commons — Attribution — Noncommercial — Share Alike
EK_3D
