Fossil Watch Cradle - updated

A watch stand for my Fossil Gen 5 (Carlyle) although it may fit other models with the same charger size.

I've since confirmed this also fits the charger for the Fossil Gen 6.

This holds the watch angled 45 degrees forwards so should show the time up the right way.

The original charger base slots into the upper half and the USB lead feeds down to the lower right hand corner.

Notes:

No supports required if you print it with the vertical section lay flat on the bed.
There's some issues with the face normals in my model that highlight top surfaces in cura, but they print fine.

The newer version “V3” of this stand has a shelf that rotates 45 degrees, so you can tilt the face either way on the base. With a 0.2 layer height this should rotate freely without issues.

The cable guide also retains the USB cable better. The edges have been chamfered