May 10, 2022
Description
A case, which holds myTTGO T5s 2.7" eInk display.
Below can be stored a18650 battery (with a single battery clip holder) and there is still space for a433mHz sender (XY-FST).
The buttons are very fragile, when the lid is not mounted. So be aware of bending them (at least if you would not like to remove them).
This case is my second version. The first was intended to be placed on a table, 45° inclined. Version 1
The idea based on the model from punkgeek
My Board Version is:
Arduino code
A little field report can be found in German on arduino.cc/TTGO T5s
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.20
Infill:
20%
Filament: Geeetech PLA White Post-Printing =============
Mounting
It´s a little bit tricky to close the lid, due to the little cutout, next to the SD-Card cover.
Arrange that part first and then press the rest softly in place.
License:
Creative Commons — Attribution
9
HerrRiebmann
