Oculus Link Cable Holder With USB Jerk Protection

I designed this holder for the link cable for my Facebook spy device.

It holds a fairly large and girthy cable, and protects your USB ports from being ripped out if you wind the cable properly, like in the image.

You'll need screws to attach it to whatever you're attaching it to. I just use normal wood screws.

I designed it to attach to the leg of my desk(a 4by4) I put a hole in each corner of the holder, but I only used two screws; you can do what you want.

You screw the holder down, then you run your cable like in the picture, you slide the bracket on, and finally, you put the two caps on and screw them down tight.

You need to print two of the caps.

I printed with 5 perimeters at .6mm LW, it's very strong you probably don't have to use that much.