Reusable Flossholder

For the “Last Meters” contest i thought it would be fitting to print something that not only uses a little of plastic, but also something that is actually good for the environment. If personally hate using floss and instead use “plackers”. These are however single use and i find it quite wastefull to trow away so much plastic each day.

My solution was a reusable floss holder that works exactly like plackers would. Just tie a small string of floss to it and go to town. I recommend only tying one end of the floss and hold the other end down with you thumb to thighten it like shown in the first picture.

I recommend using PETG or any other durable plastic and 100% infill to make sure its sturdy. The print took about half an hour with 0,15mm layer height and only used 1,2M of fillament.