February 19, 2023
Description
Toothpick / micro canopy, this is a light, strong and versatile canopy - 25.5 x 25.5 mounting points.
The canopy houses components:
Note - a newer lighter (1g) canopy for - HDZero - Nano lite - https://www.printables.com/model/401939-whoop-micro-canopy-hd-zero-nano-lite-camera
Also see:
Battery mount - https://www.thingiverse.com/thing:4831044
Whoop canopy (small antenna) - https://www.thingiverse.com/thing:5235436
Hardware - M2 countersunk bolts (x4) & M2 nylon nuts (x4)
Fitting is achieved by using M2 countersunk bolts, for the Shark Byte system I use M2x20mm, if you are only using one board then shorter countersunk bolts (10 or 15m) should be used. These are fitted from the bottom with M2 nylon bolts on the top (these are recessed into the canopy).
BetaFPV HX100 SE build - specifications:
Frame - BetaFPV HX100
Flight controller - JHEMCU GHF411AIO F4 - (Previously I had used a Flywoo F745 but that is being used on another build and swapped for this more budget FC)
VTX - SharkByte @ 25mw
VTX antenna - Lollipop 3 style
Camera - Runcam (SharkByte) Caddx glass lens fitted - this lens is an improvement on stock and fits the canopy in terms of full protection
RX - ELRS PP
Motors - Eachine EX1103S KV7000
Custom design battery mounts - 3D printed in carbon fibre nylon & TPU bands also includes solid XT30 mount - https://www.thingiverse.com/thing:4831044
Battery - BetaFPV 2S 350mah / GNB 2S 450mah
Props - Emax Avan Rush 2.5
Weight - approx. 57g (ex battery)
ESC firmware - Blue Jay 0.16 @ 96khz
Flight controller firmware - Betaflight 4.3
Presets for Betaflight:
Printer:
Qiditech One
Rafts:
Yes
Supports:
Yes
Resolution:
200
Infill:
30
Filament:
PolyMaker ABS or Carbon fibre nylon is preferred
any
Notes:
Stronger and lighter with carbon fibre nylon.
Category: R/C Vehicles
License:
Creative Commons — Attribution
10
Bacon2002
