May 19, 2022
Description
This is a remixed design of the "Keurig K-pod holder / dispenser, space saving by d0ughb0y". I had to cut it up some to make it fit my print bed which reduced the original size by a little more than half. I removed the original "T" shaped tabs from the pieces as I had more trouble getting them to interlock correctly than I wanted to deal with.
Additional top and bottom pieces can be used to make it wider as needed. The top piece can also be stacked above other top pieces to provide longer columns depending on your unique situation.
The quantity for 1 top and 1 bottom piece is 16 pods.
Picture 1: Side view
Picture 2: Bottom-up view
Picture 3: Top-down view
Printer:
AnyCubic Mega Zero 2.0
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:
Generic PLABlack
Notes:
This was printed with the stock nozzle at 60mm/s
Cleanup/Mounting
Just sand down the edges as needed and mount using double-sided mounting tape.
License:
Creative Commons — Attribution
JGrantham61414
