Wilderness Krate spacer for middle rod holder risers

The Wilderness Krate fishing crate allows for 6 rod holders, but you have to lower the middle two or cut off the center tie-downs. With this spacer, you can have the height and an unblemished Krate. 

In addition to the 4 spacers, you will need:

• four 1/4 in.-20 x 3/4 in. Hex Socket Head Stainless Steel Socket Cap Screws*
• four 1/4-in x 20 Stainless Steel Nylon Insert Nuts**
• two Wilderness riser brackets

*Lowes had the screws in-store, but the website doesn't seem to list them.

**You can also substitute metric-equivalent screws and nuts. Stainless steel is recommended.

I printed with Prusament orange PETG with 50% infill for increased heat resistance and structural integrity. I lightly hammered the nuts into the holes. I used bobstro's supports on the build plate only (see screenshot).