UV Resin curing fiber optic flashlight wand

This thing Allows you to cure your hollowed out models through your drain holes.

you can attached 2mm or 3mm fiber optic cable to the end of a UV flashlight and use this flexible wand to cure the inside of your model.

Curing the inside of the model completely will help prevent models form leaking or potentially exploding do to leftover resin in the model.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Notes:

print as oriented.

NOTE: some slicers detect the small parts and want to change scale. if prompted say NO.

"main cap" should be able to be printed without support. make sure to remove the sacrificial layer from the center hole. this may be a little rough due to the bridging, but it will not be seen when installed on the flashlight.

See video for demonstration of assembly and needed parts https://youtu.be/bFVhwOp6T1s

Category: 3D Printer Accessories