Sharpener Micro Adjuster

This adapted design of the original project came about as a result of the lack of appropriately sized hardware, and need for a 3D printable alternative. So I combined the Fine Tuning Adapter for Knife Sharpening Jigs, with a resized and modified nut and bolt from the NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory collection from here on Printables.

Also because the main source model is from Thingiverse I cannot list it in the model remix section. However, I am stating here that all of the credit for the creation of the original, high quality, model that I used for this remix goes to Burt at Leadingedge on Thingiverse. Here I have included a link to the original print. https://www.thingiverse.com/thing:3644585 

Print Settings:

Printer:

Prusa MK2S+

Filament:

CPE, or Tough PLA

Layer Hight:

0.15

Infill:

80% to 100%

Exterior Perimeters:

5

Brim:

5mm

Heated Bed:

Recommended

Supports:

Everywhere, snug, and at 43 degrees overhang threshold.

Approximated Filament Usage:

3.79m

Approximated Print Time:

1 hour and 38 minutes.