Compliant Phone mount

Compliant cell phone holder.

I wanted a phone holder in my car that was easy to use. I can use one hand to put my phone in the holder and remove it.

I used PolyCarbonate to print this so that it would take the heat in the car. should be able to use PETG as well

I used alien tape to attach the base to the dash.

I used a piece of filament for the three hinges. you may have to drill out the holes to clean the inside. then I used a soldering iron to melt them in place on the ends

Category: Mobile Phone

New ball mount and stronger spring use 20 x 3mm screws and nuts to mount the ball to the stand and the clamp together.

the spring, you will need to add supports and 100% infill

for the ball, also print at 100% infill as well

all the parts are correctly orientated for printing