Raspberry Pi 3/4 DIN Mount

Based on the ingenious design by jwags55. This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this mounts the boards slightly closer to the rails.Note: It's really easy for me to tune the parameters so if it's too loose/tight let me know in the comments and I can make some adjustments.

Features

• Snap fits to DIN and Board (No screws needed)
• Works with PLA
• Low profile
• No tools required
• Easy and fast to print (No supports)

Printing Tips

• Use 4 perimeters
• 4 Top/Bottom layers
• 20% Gyroid infill
• 20% Gyroid infill

Print Settings

Printer:

BLV Cube

Rafts:

Supports:

No

Resolution:

Infill:

20%

Filament:

Radio Shack :-) PLA

Blue

Notes:

Category: Electronics