Small dustpan V2

My previous design was too thin and caused the edges to crack and break apart.

I have thickened the walls and made it slightly shorter while maintaining the overall width of 150mm. All these changes will improve structure rigidity.

I have printed in yellow ABS and observed some warpage at the thin wall areas holding the stick. Not a big issue to me, don't expect to see this if printed using PLA.

Clicking on my AliExpress affiliate link below will give me a small kickback 
if you purchase something within 3 days. (at no extra cost to you) https://s.click.aliexpress.com/e/_DmpFxU1