Shower head holder V2

This is a remix of my previously published Shower Head Holder.

For 22mm shower-rod diameter.

It uses one screw only for both fastening av adjusting shower head.

Use preferably PETG because it is more water resistant.

Other parts are:

• 1 pc. 40 x 5 mm screw with fastner-nut.
• 1.pc. 40 to 50 x 5 mm screw with hex head.
• 1 pc. rubber gasket. Print from flex filament or cut out of a broken bicycle hose.

Use a threaded rod to brush up the threaded holes after printing if needed.

Se also Shower Soapdish.