Harry Potter Board Game (with a Wand)

Used Blender to remodel Harry to be more in a fighting position with a wand. its a little tricky to print being the wand is so narrow. I thought it would be a better position for the game being they are supposed to be shooting spells at each other.

Added the other pieces from Raymond31415 to make the whole game in one place.

Update: added a modified Voltemort with a wand also. Need supports, be careful removing them around the wand and fingers. Wand is small and may not print if the figure size is reduced much.

Update2: Finally printed the entire game set and tweeked the models a little has I went. One issues I found with an earlier Voltemort wand model was I had the hand to far extended and would collide with a shield. I printed everything in PLA with the colors in the names. That is the primary color for each house, being I can't do any dual color prints I went with only the primary color. I used the old white black hat from the cowboys and printed Harry white and Voltemort black. I also tweeked the Gryffindorf school shield to have the lion facing to the right as they have in the movie version.

Good luck printing

Print Settings

Printer:

FLSUN Q5

Rafts:

Supports:

Yes

Resolution:

Infill:

25%

Filament:

Hatchbox PLA

Black

Notes:

Post-Printing =============

My final version I did with each print in the primary color of the school. Only issues was cleaning out the supports.

Category: 3D Printing