Voron V2/VT 7" Display Mount

This is a simple mount for the BTT PiTFT70. All parts should be printed in Voron-Spec, no supports needed. STLs are oriented the correct way, no need to change stuff around.

BOM:

• 1x M3 T-Nut/Hammerhead Nut
• 1x M3x8mm SHCS
• 2x M5 T-Nut/Hammerhead Nut
• 2x M5x10mm BHCS
• 4x M2,5x14mm BHCS OR 4x any M2,5 longer than 6mm
• 1x PiTFT70
• 1x Flat Flexible Cable 50cm or longer for Pi Cam/Pi Display

Print Settings

• 4 Walls
• 5 Top/Bottom Layers
• 40% infill
• 0.2 Layer height

Installation

1. Attach the 2 Mounts to the Frame with the M5 screws, feed the Cable through the Slot in the middle Skirt and mount it with the M3 screws.
2. Feed the Cable through the back of the Housing and attach it to the Display (unisolated part faces display). Use the Raspberry Mounts to attach the Display/Housing to the Frame.
3. Simply Push the Front Housing onto the back, it should fit
4. Connect the FFC to the Pis Display port (unisolated part faces towards USB).
5. Install Klipperscreen via KIAUTH or by doing it manually.
6. If the Display is flipped upside down, hit the toggle switch. Adjust the brightness as needed.

FFC Routing

CAD-Files can be found on the voronuser_mods github