Samsung Watch 4 Docking/Stand

The charger supplied with the Samsung Galaxy Watch 4 is a simple one. So I decided to create an elegant stand to support it. 

For the best result use a layer height of ≤ 0.12mm. 

Two version of the stand are provided :

• Single : One piece, clean finish 
• Split: Two pieces, easy print

Before you start printing it's recommended to determine the supported overhang for your setup. This can be done using one of the many overhang models.  To get a good indication use the layer height and fan settings mentioned below. If your supported overhang is below 65° use the “Split” model to reduce print time.

Instructions (Single)

Settings :

• Layer height : 0.12mm
• Raft : yes 
• Fan : 100%
• Support : Touching build plate (Overhang < 75°)
• Support : None (Overhang ≥ 75°)
•  

Assembly:

• Not needed

Instructions (Split)

Settings :

• Layer height : 0.12mm
• Raft : yes 
• Fan : 100%
• Support : Touching buildplate (Use overhang supported)

Assembly:

• After print assemble the top and bottom part using some CA glue and 3 pieces of filament.