Leatherman Juice Belt Holster, single-finger access (Tested-inspired)

While looking to optimize my shop time, I was inspired by Adam Savage's custom Leatherman holster. It doesn't seem like a big deal, but the single-finger quick draw this design affords really helps when in the thick of a project.

This is a bit of a tricky print due to the thin profile of this part. It is strongly recommended to print this standing up vertically. This allows a supportless print. Ensure your bed adhesion and 1st layer calibration is good. I added a 2mm brim and slowed the first layer down for extra insurance.

PETG is a good choice for this because it's impact resistant and has really good inter-layer adhesion. I'm sure PLA will work too.

This was designed for a Juice S2 - hopefully it fits all variants of the Juice.

If I print this again I might scale it down by 2% to tighten the fit just a touch more. I can turn the holder upside down without incident already so it's probably fine as is.

Side note - it would be nice if Thingiverse didn't automatically place YouTube links into the thumbnails. It makes it look like I'm affiliated with Tested - I most certainly am not - just a fan.

Category: Tool Holders & Boxes