Volvo V70 compatible panel clip

These clips just like the originals, where you press the pin flush to lock, and press further in ( 4mm ) to unlock. 

There are “supports” you can import with the clip body if required. To import them first import the clip body, then right click and choose “add part”, and select the supports. If you print the with the imported supports, tweak the print settings for the “support” components by right clicking them in the part tree, and adding infill and layers + perimeters overrides. 

Support Part Settings: Infill should be be grid infill ±30%, Perimeters, Top and Bottom all set to 0. 

Use a brim ±2mm for the clip and the pin!

Use low variable layer height for the overhang, 0.05 → 0.07mm 

The clip pin is to printed upside down, with the beveled edge on the print bed.