Corgi Phone Stand

General

Inspired by a few of the phone stands available out there I wanted one that I can easily grab my phone off of, with or without a charging cable attached but had some uniqueness factor to it. Corgis are cool and so with this available model, I was able to come up with this phone stand. 

Use either double sided tape or nano suction adhesive (what I recommend) to keep it on your desk.

Phone Stand Properties

• Larger openings to support bulkier cases or larger phones
• Extra back support should allow for portrait and landscape orientation
• Extra gap from where the phone stands to the base should allow for larger sized charging cables

Printing

I printed this on a 0.4mm nozzle using PLA at 0.2mm layer height. I used a standard cubic infill at 15% and it feels pretty solid. 

There's two ways you can print this in regards to overhangs, you can either add supports OR (what I recommend) use the Cura Experimental option Make Overhang Printable. I used the default settings for it but you can mess with the overhang angle setting to get your desired outcome. While it changes the model a little bit, you don't really notice the changes (specifically under the ears, by the tongue and the tail) and you'll save some filament not printing supports.