July 17, 2023
Description
Load assist button for Smith & Wesson M&P 15-22 magazines. In case you lost one or were finally able to move to a free state and converted your old 10-25 magazines (which do not come with a button) to standard capacity.
Printer:
Folger Tech Kossel
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
0%
Filament:
FilaCube PLA2
Notes:
No fill but I used 4 walls.
To get it to stick I used a brim and support.The STL with the "print nubs" should be oriented nubs down to lift the part from the build surface. This will suspend the part and prevent flat spots. I suggest blocking support on the end of the button to improve the finish of the visible portion.
Remove supports and clip off print nubs (if they didn't come off while removing the support material).
Reverse engineered from a factory load assist button.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
11
AlanR1138
