Cooler Master / Antec Centurion Hard Drive Rail

Even with the printer calibrated, I was having problems with shrinkage pulling the pins on the original part closer together. After scaling to compensate didn't help and not caring about it being tool less, I just changed the pins to counter bores located on the original pins.

Added a second set of mounting points for 2.5 inch drive adapters.

Without the pins it may be printed flat on the bed.

The pins on the original are off center. I didn't bother to fix that because the tolerances are really loose and it works just fine.

Print Settings

Printer:

Folger Tech Kossel

Rafts: 

Doesn't Matter

Supports:

Yes

Resolution: 

.2mm

Infill:

10%

Filament:

FilaCube PLA2

Notes:

I used a brim to keep the end from coming loose.

Category: Computer