November 4, 2022
Description
A plant pot on 3 stilts. The pot itself has a small hole at the bottom end to drain water. The base has a small hole in the middle to catch the water and conduct the water in 3 directions in the pool. 15% infill for the base should be good enough.
Instead off the printed poles you can use metal also if you have but its not a must have. The poles have a diameter of 6mm and a length of 200mm. Put the seam of the pot behind a stilt so you have a clean surface. Just print walllines 0.2 and no infill for the pot.
The poles should be printed with 3 walllines and minimum 20% infill.
Enjoy
License:
Creative Commons — Attribution — Noncommercial
Flotschi
