October 5, 2022
Description
Simple print for a sandstone coaster holder. I put a few rubber feet on the bottom of mine. Print in PLA, 20% fill or higher. The design is NOT super strong - but well strong enough to hold coasters.
The gap in the base for the holder is 2% bigger than the holder - in the few of these that I've printed, they've fit snugly without any sanding.
UPDATE 2022-04-24 - v1.3 - Better rounded edges, better base support and now uses less material on the angled/holder portion due to 4 rounded cutouts.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Nem
