Light Switch Cover

This is a plain, ordinary, everyday light switch cover. There's nothing particularly exciting about it.

I created it since it was tough to find a plain cover that looked properly sized and reinforced that could print well. I modelled it after a cover that I had around. The edges are angled rather than the usual smooth curves since similar models with smooth curves were difficult to print due to the overhang.

This model should be printed with the visible side (side facing out when on the wall) against the print bed. No supports are necessary. Infill is up to you - there is so little that it likely won't have any effect on the print.

The print seen in the photos used 0.2mm layer height, no supports, 100% infill, using Overture Matte Green, sliced in PrusaSlicer, and printed on a Prusa Mini+.