20mm conduit connector with inspection hatch

This is a conector for conecting two pieces of 20mm conduit together with an inspection hatch in the middle for pulling cable through. The conectors are push fit and will hold with friction but can be hot glued if required. The inspection hatch cover is held on with four 3m screws wich can be screwed directly in to the plastic or in to threaded inserts depending on how the mode takes you. 

It is desighned to print with ease without any supports when printed base down other orientations i can not vouch for.

V1.1 is redisghned with slightly larger holes due to a prior miscalculation. It is advised to print this version