CR10/CR10S Hot-End/X-Motor, Heat Bed Cable Management

Description

I upgraded my heatbed to use a silicon heater pad, and wanted to be able to easily attach/detach the heatbed and add a thermal fuse.  I've used Wego221 lever nuts to make life easier.  

This mod will also work for folks with the standard Creality bed- just clip the wires with enough slack to run though the lever-nuts. Note you do not need a thermal fuse for this setup.

Along with the bed mod, I'm also including my x-axis/extruder cable management mount for the CR10/CR10S, and a dual drag-chain mount point for the back right of the printer. Note that this mod does not work for bowden systems as it uses the old bracket on the x-gantry where the e-motor was mounted to security attach the drag-chain.

Bill of Materials:

Heated Bed:

Note the slightly different bill of materials for the silicon heater pad vs Creality stock.

with Silicon Heater Pad:

4x M3 brass heat-set insert 

1x 230v 125C thermal fuse

5x Wego221 lever-nuts

3x M3x5mm bolts

VHB Tape

Zip Ties

with Stock Creality Heated Bed:

3x M3 brass heat-set insert 

4x Wego221 lever-nuts

3x M3x5mm bolts

VHB Tape

Zip Ties

Extruder/X-Axis:

6x M3 brass heat-set inserts

6x M3x5mm bolts

Zip Ties

Dual Drag-Chain 2020 Mount:

6x M3 brass heat-set inserts

6x M3x5mm bolts

2x M5x10mm bolts

2x M5 T-nuts

Notes on the Drag-Chains

The drag-chain attachment point uses a generic 3 screw setup, and can accommodate drag chains up to 20mm wide channels (28mm exterior width).