Lack Enclosure 4mm acrylic door + 5mm airpocket PC

My first version of Lack Enclosure needed an Upgrade.

• Better sealing of side panels.
• thicker side panels
• better noise reduction
• better thermal insulation
• cheaper material
• use single-screw-leg-design by Ikea in the new Lack-Version

I had available:

• 5mm very cheap Polycarbonate Air-Pocketed greenhouse sheeting for the sides and
• 4mm clear hobby-acrylic-derivate for the front door.

My design let's side panels bond flat to the legs and top of the table, perfect for silicone sealing yet bottom parts allow complete removal of the top table.

Twin screw-on-design for upper standoffs allow easy door hinge installation and stay clear of the single leg-screw inside.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2 mm

Infill:

Notes:

The door knob and door backplate have slots for magnets to be placed inside during print.

Stop the print at z-height 4.00mm and 21.2mm.

Slot four 10x2mm neodymium magnets inside, two at each stop. Check polarity!!!

Category: 3D Printer Accessories