July 5, 2022
Description
This mount specifically fits the Swarovski binocular mentioned in the title. It is wider than the original model. It requires a 1/4 size 20 nut. I would suggest using PETG rather than PLA, it should handle the stress better over time (flex rather than break or become loose). Print it in the orientation of the included file with the face of the C flat on the bed. I used 4 perimeters and 50% gyroid infill for strength. 0.15 layer height. The nut was a tight fit for me, I had to hammer it into place. Also, I rounded off the edges a bit from the original model to hopefully prevent scratching the binocular surface.
License:
Creative Commons — Attribution — Share Alike