UniFi G3 Instant stroller mount (detachable)

This was a quick and cheap way of getting a baby monitor mounted to our stroller. The camera works over WiFi and can be powered via a power bank for quite a long time.

The camera is easy to detach from the mount by simply sliding it out. The mount itself is secured to the stroller's handle with plastic rings. Note that the sliding mechanism is a bit more loose than I was hoping for, but so far the camera hasn't fallen out :-)

Parts needed:

• One M6x16 countersunk screw

Instructions:

• Print both parts, I used PETG since at least the rings will be exposed to direct sunlight
• Using the M6x16 countersunk screw, attach the G3 Instant camera to the G3 mount.
• Install the Stroller mount part to your stroller, be careful not to bend the rings too much (I found sliding them in from a more slim part of the handle worked better)
• Slide the G3 mount into the stroller mount

Attached f3d file if you need to make tweaks for your specific stroller.