35mm Film Digital Mirrorless Scanner Holder

This one is mix from few different models that I have found on web. What I did are adjustments and addons. 
Main 35mm slide model is this one (https://www.thingiverse.com/thing:4620992)
 

Film slide housing is slightly wider than 35mm film so that you have more space to adjust your film and move it more freely. Also it is easier in post to crop that to lose parts of your image!

You can use any LED lights but make sure you are using soft ones (with supper small LEDs) or use silicone diffuser since if you don't, you will be able to see different LED diodes behind you negatives!

Top tube can be replaced and adjusted for your lenses, just measure your lens minimum focus distance and add few cm (to be safe). Then create a tube that will fit your lens and then just use tube connecting ring to hold it in place on top of main tube. Note that bottom part (3-5cm) shout stay same diameter if you want to use this tube connector and only after those 3-5cm you can start widening it to conform your lens diameter.

Also I would advise using some dark silicone to connect main tube and 35mm film sliding compartment to prevent light leaks. 

Also silicone should be used for feets but you can use any type of glue/adhesive since main thing is to have them glues to the body.

Printed in PETG and @ 0.2 with 0.4 Nozzle. You can use whatever you want but for me PETG is something that I am using for everything :) 

Hope this is helpful! It, certainly, was for me since it helped me to digitalaze some 1000 old negatives and bring them back to light :) 

Also please feel free to play with it and if you have any ideas for improvement please share them with us and upload your remixes and makes since it will help others.