February 26, 2020
Description
A cute litte holder for your keys. Opens the eyes and folds out the wings when you give it your keys.
Layer height 0.2mm
No supports needed.
Two 8x3mm neodymium magnets.
Print in the color you want the eyes to be when open, e.g. black.
No special instructions
To print the beak in another color, switch filament after 5mm (i.e at the start of layer 5.2 if using 0.2mm layer height)
Use FrontplateMMU and BackplateMMU. See last picture for color areas.
For maximum strength the magnets should be rotated so that they attract each other when inserted in the slots.
A drop of super glue to hold the magnets in place makes assembly easier but is not required.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Harald Andersson
