Pikachu Lamp remix

Print using supports in almost every part.

For lightings, best print in cura, using tree supports, 3 perimeters, 3 top and bottom layers, this way al interior is completely clear, in prusaslicer I cannot print it clean lot of artifacts

remixed for usage arduino nano and led strips 2812b.

Build is rather similar, just need to solder lights, mantain signal from first to last led. only 18 leds and upload code to arduino.

order is as follow

leds_head_pikachu.stl holds 4 leds, and are first on montage

led 0, red
led 1, yellow
led 2, yellow
led 3, red

led_base_pikachu.stl holds 2 leds, 

led 4, yellow
led 5, yellow

tail.stl holds 3 leds, 

led 6, yellow
led 7, yellow
led 8, yellow

remember to use same signal wire or will not work, mantain order.

once pikachu asembled, let enough cable to work confortably, all cable will be hidden in base so no need to be extreme clean

all remaining leds are in light blue, so no need to be carefull in this part, just remember to mantain signal wire in correct order

3 lightings, needs 6 leds, 2 for each one

led 9, blue
led 10, blue
led 11, blue
led 12, blue
led 13, blue
led 14, blue

finally, just need to mount impact, this one holds 3 leds

led 15, blue
led 16, blue
led 17, blue

just glue remaining parts and job finished.

also you get the arduino code, easy and no complications, plug, compile and start lighting.

Arduino uses a button, with this one, you can control light, it has 4 brightness and an off position.

in the pin data cable, add a 10k resistance, to avoid bugs.

thanks to rayjizza for allow me remix this fantastic model.

https://youtube.com/shorts/KdQprj2fj3s