CY7C68013A box for logic analyzer

This is a remix of the low profile version of https://www.thingiverse.com/thing:2153437 by @bobtidey. I created a cap for the power button, extended the lid 1mm to center it better over the I/O pins and added a little hole over the reset switch that allows resetting the board with a toothpick or similar item.

The lid is oriented upside down compared to the original version. On a printer with a glass build plate, the bottom side is usually smoother and therefore the top of the lid gets printed in a better quality if printed this way. The overhangs on the sides are 45° and can be printed without supports.

I added a SVG & PNG version of a lable that you can put on the lid.

Print Settings

Printer Brand:

Ultimaker

Printer:

Rafts:

No

Supports:

Resolution:

0.2 mm

Infill:

Filament: DasFilament PLA Black

Notes:

Post-Printing =============

The corners of the lid that face inside the box needed a little bit of sanding to round them a bit. The power switch cap is a tight fit. Press it down and it should just snap onto the switch.

Category: Electronics