Sliding LACK GoPro-like camera mount

A camera mount that clamps around the leg of a LACK table and can be easily adjusted vertically by loosening/tightening the large screw. Fits GoPro accessories for adjustable camera angles. Can be used on any of the four legs by changing the orientation.

I use it with the Prusa Printer Enclosure V2 where I have a small gap between the acrylic plates and the table legs.

UPDATE: New clamp that can be printed without supports

Print instructions

PLA is to brittle for the clamp because of the thin walls. I printed mine using PETG instead and it holds up fine. For the screw and plate I used PLA, but PETG should also be fine.

If printing from stl, you will need support from the print plate underneath the GoPro-mount. There is a vertical support inside the screw holes. Remove with pliers/knife/small screwdriver after print.