June 15, 2023
Description
Just a simple wall mount I made in for my DJI Phantom. I only used custom supports in cura on the hooks so they didn't sag too much. Otherwise no supports. To hang, put your screw into a wall stud close enough for the hanger's lower back portion to sit up against the wall.
Printer:
Longer LK1
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.2
Infill:
15
Filament:
Sunlu PLA+Red
Notes:
Print upright. Add custom supports to hooks if you want.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
JohnMartin
