3D Maze (4x4x4)

I wrote a program to generate 3-Dimensional mazes and this is a small maze that I made from the output. Turns out mazes are a lot more difficult when you can't see it. This is a ‘perfect’ maze meaning there is only one path between any two points in the maze. It may be helpful to mark the entrance hole so you don't end up going back out. I'd be interested to see if anyone can get a good clear print on this so let me know if you try it. If enough people want a larger one I'll upload a more complex version, but 4x4x4 is a lot harder than it sounds. It gets pretty tough when you are only going by sound.

I also created a version meant to be held together by some nails so you can remove the bb (or take a peek) if needed.

Print Instructions:

No support material is needed, if you want to scale it up and your printer doesn't do overhangs well then you can safely rotate it by 45 degrees in the slicer onto a corner and print with support material on print bed only. If support material is generated inside, you will not be able to remove it! Infill 15% worked just fine, unless you try a clear print then you need 100% obv.