Satsana Ender 3 Fan Duct for CR-Touch

This is a modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro. This shroud is modified to fit with the Creality CR-Touch touch sensor, using the standard hardware that comes with it.

Printing:

Take note of the printing picture above. You will need to use a block object to prevent support generation on overlap, so that the bottom connecting sections will be supported only.

I printed this at .16 layer height, but im sure .2 would do just fine.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: Overture PLA Post-Printing =============

Post Printing - using an exacto blade or razor to remove the supports from the connecting sections seen in the image below. This will allow room for the Cr-Touch bracket to install properly.

Category: 3D Printer Accessories