L Bracket for Kitchen Chairs

A simple L Bracket for a table chair that I recently bought on sale. Unfortunately, the cross supports at the bottom don't take foot-restin' too well so I added these to reinforce them just a little bit more.

NOTE: This is NOT a general use bracket! Instead of using a right angle as with most L Brackets, this one uses an obtuse angle of 96.4 degrees to fit the leg and brace angle perfectly. Also, there's a bulge on one of the through-holes so that it will recess into the manufacturer's burrowed-out screw hole and allow maximum material contact with the cross-member.

Print a single, a pair or four brackets at once. Use a razor to separate them (and sand the corners before painting, if desired).

If you found this useful, please share your work and be sure to peruse my other submissions which are almost as varied as they are many:

http://www.thingiverse.com/3E8/designs

Enjoy!

Category: Kitchen & Dining