Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 1

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 2

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 3

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 4

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 5

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 6

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 7

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Image 8

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 1

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 2

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 3

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 4

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 5

Head mount for Armytek Wizard with rubber ring (+other 18650 lights) 3D Printer File Thumbnail 6

Head mount for Armytek Wizard with rubber ring (+other 18650 lights)

Slaig

Description Comments Tags

Description

Instructions

PETG or water resistant material recommended.

Print in place on the flat side, with 100% infill, no supports needed:

Headlamp_holder_with_rubber_ring v1 (stl or 3mf) is recommended and the most versatile
or
Headlamp_holder_with_rubber_ring_closed v1 (stl or 3mf) as stronger alternative if you do not need open side for the headband

Enhancements

Major enhancements

	Function	Description
1	Stronger conception	Thickness increased to 3mm
2	Allowing headband clearance	“Arms” raise by 2mm, so the headlamp does not block the headband
3	Rubber ring slots	One side designed to always keep attached the rubber ring, the other one is designed for a relatively quick release (see gif) Designed for the original o-ring (3 mm width, 25mm interior diameter) but anything similar should work, rubber band for exemple.
4*	Allowing mounting for sewn headband	Cuts are made on each side to allow mounting any closed headband like the original Armytek one I had which made a loop on each side. * I made a file without the cuts for better strength if needed : "Headlamp_holder_with_rubber_ring_closed" (stl and 3mf).

Minor enhancements

Wider parts for strength
Fillets for best strength results with printing process.

Design

I remixed the original fusion 360 file from Citruspers (Headlamp_holder_v14.f3d), the new project file is attached (Headlamp_holder_with_rubber_ring v1).