Skadis mount for Wera Kompakt 10 or Wera Kompakt 12

This is a little spring-loaded Ikea Skadis mount for my Wera Kompakt screwdriver kit.

Bill of materials:

• 1x M4x30 bolt. Make sure to use a thick head since this is what keeps the tools in place.
• 1x M4 nut
• 2x M4 washers
• 1x spring (Mine is roughly 19mm long, has a diameter of 7mm, filament diameter of 0.5mm and 5 windings. While the length should be chosen similarly, you can easily downsize the total diameter as long as the spring fits over the M4 bolt)

Printing:

Print this with the upper surface (oriented as seen in the pictures) on the build plate. I recommend using supports for the steep overhangs though the hooks themselves should print just fine without.

Assembly:

1. Push the nut into the end cap. The tolerances may be quite tight. In this case you can use a heatgun to warm the part up a bit or just use brute force.
2. Slide a washer, the spring and another washer onto the M4 bolt.
3. Put the M4 bolt through the hole on the right side of the mount with its head facing inwards.
4. Screw on the end cap that you prepared in step 1