Shelly 1PM PLUS case - no insert

⚒ No 3D printer? No time to source components?
I just opened my new e-shop where you can buy physical, ready-to-use versions of my models! Designed with passion, printed and assembled with care ⚙.
📦 Shipping across the EU: 👉 Get it at NautilusForge.shop

Remix of this holder: https://www.thingiverse.com/thing:4974328

In complement to @cnrd I remixed the version with WAGO from thingiverse

• Uses screws with diam slightly superior at 3mm instead of inserts from original model, 

• No support, Prefer PETG

Text from Thingiverse original model, I remixed:

“

Shelly 1PM PLUS case for "on cable" wiring (similar to shelly button).

The other relays in the PLUS line are supposed to have the same external dimensions, so theoretically they should all fit, but this model was made specifically from the 1PM PLUS dimensions (which, btw, are considerably larger than the official specifications, by more than 1mm on all sides).

The Shelly 1PM PLUS relay version features additional N and L terminals compared to the old 1PM, so you shouldn't need an extra connector anymore, hence the version without wago connectors.

Features:

• A version with room for 2 WAGO 221-413 connectors

• cutouts on both sides for better ventilation and you can easily see the whole diagram on the shelly upper side, and also access to the button and connectors on the other side.

• side cutouts and gaps above and below the long relay side, for better ventilation (see section image)

• the cable holes are for 8mm cables, and there are slots designed to hold the cables in place with zip-ties

• recommended filament: ApolloX modified ASA based 3D printer filament, high strength and heat resistant

"