Static Hook

This is a small hook to hold a Ninja Coffee measuring cup.

I was using a commercial hook to hold the measuring cup but it was difficult because to use because the little wire hook would raise when I tried to remove the cup.

This one is modeled after the commercial hook and I use the two-sided tape to mount it to the side.

I needed to drill a small hole in my measuring cup handle in order to hang it on this hook.

I think this can be improved if I were to not use a curved hook shape but more of an angled hook so the cup sits flush at rest and probably will make it easier to use too.

Print Settings

Printer Brand:

Ultimaker

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: Ultimaker Tough PLA, PLA Black, Icelandic Blue

Notes:

Category: Kitchen & Dining