Build your own knife holder with the PrusaSlicer

Did you know that you can assemble models with the Prusaslicer? I have divided my "simple knife holder" into different sections. I also created spacers. You can assemble these with the PrusaSlicer into your own simple knife holder.

Here the instructions:

Load the first part and position it using the x and y coordinates

Use the “+”-button to duplicate the piece. Remember to make it as a separate object. Of course you can also load one of the other parts at this point

Roughly slide the second part to where it meets the first part. The exact positioning is done again via the x and y coordinates

Mark the two parts on the right side and use the "Merge" command in the context menu

Here is the result after slicing. Repeat these steps until you have your own "simple knife holder" ready.

Left to right:

1. End piece with knife holder 13mm
2. knife holder 13mm
3. Spacer 10mm
4. Spacer 5mm
5. Spacer 2mm
6. Spacer 1mm
7. cap

Here is an example of a complete holder: