CR-6 SE Z-Axis Linear Rail mount

Update 12 Dec. 2021

I'm currently working on another Z- and X-Axis linear Rail Mount thing…

Update 03 Aug. 2021

I noticed that I had a lot of wobbling after the modification. When investigating the cause, I noticed that the brass nuts had a lot of play, they had been rinsed out properly!

Then I made these anti-wobbling parts (https://www.thingiverse.com/thing:4871212) with these T8 lead screws anti backlash nut (https://www.thingiverse.com/thing:4227492). When assembling I then definitely found the cause of the worn out brass nuts: The T8 lead screw was not centered with the hole in the guide, so I also created and installed the "Unterlage" (didn't find the english word), Left and Right.

• This are MGM12H HiWin Linear Rails 370mm
• Linear Rails should be 300-370mm
• you may need 1-2 washers if the screw scratches

Print Settings

Printer Brand: Creality

Printer: CR-6 SE

Rafts: No

Supports: No

Resolution: 0.20mm

Infill: 40% Gyroid

Filament: purefill PETG light green

Notes:

PUREFILL PETG
240°C/70°C (first Layer 245/78)

Slicer: Cura 4.9.1

Wall: 4x 0.45

Speed: 60/30 mm/s

Infill: 40% Gyroid

Extruder: Bondtech LGX

HotEnd: Slicer Engineering Mosquito, 0.4 mm Nozzle