2S JST balance connector grip

Grip to make it easier to pull 2S JST balance connector from chargers.

Print the parts, split the parts in slicer software and place them flat on bed.

Once printed place top and bottom shells over connector & snap together, fix with a wrap of electrical tape or heat shrink (22mm un-shrunk) over the entire grip body, to keep it together.

Work with Syma x8C X8HC X8W X8HW X8G X8HG or any normal 2S battery pack with JST style connector (3 pin).

Note: This grip was compatible with all the connectors that came with the various batteries shown -but did not fit a replacement connector housing I purchased from an overseas source - I suspect that connector may not be to specification. If they fit, the connectors should almost feel like they click into the grip shell- if this is not the case on your connector, use a sharp knife to carve some off the connector body to make it fit.

Print Settings

Printer Brand:

Printrbot

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Notes:

I found it helped to print slowly as detailed parts.

Category: Models