Fabrikator Mini V1.5 replacement bed

Laser cut-able replacement bed for the Turnigy Fabrikator Mini V1.5.

Instructions

Laser cut from 3mm Acrylic (takes about 2 minutes on a 40W laser),

Replace existing bed (fixed with 2mm head hex screws, you may need to move bed left and right to access rear screws),

The smaller screw flange goes towards the rear.

Back story

I bought a 2nd hand Turnigy Fabrikator Mini V1.5 (I always wanted one, don't judge) recently and I'm gradually refurbishing it. Previous owner had burned a divot into both sides of the bed, so kinda needed replacing (I also wanted to have some spares), but there didn't seem to be a file for this anywhere. 

I fit a little bit of BuildTak (clone) to it and has printed fairly happily so far (2 prints in). Am tempted to add another piece of BuildTak to the other side so I can flip it over when worn out!

Bit of a shame I couldn't find any matching clear Orange Acrylic in my local hackspace scrap bin! Had to cut it out of clear instead.

NB: Picture features a little bit of text at the front to indicate the front. Realised that this is a little pointless (printer won't work if bed on backwards), so I removed it. It also made cutting in Visicut a little easier!