Longshot Bolt Handle replacement-uses original bar

Replacement part for a old Nerf blaster toy. The original bolt handle came off due to the insides breaking (should look like this but the part that contacts the metal was broken off entirely). I wanted to replace the just broken part.

I think the Longstrike bolt is the same, though I am unsure, so I guess it might work on that as well.

I'd advise you to print this in a brightly coloured plastic.

Fit should be pretty snug and secure, if you print Bolt test fit.stl you'll find out whether or not you need to scale up. I measure the metal part it attaches to to be about 4.6mm so I made the hole 4.8mm, which seems good. A tiny piece of thin tape wrapped around the metal part also improves fit, very well. Print X and Y at 101-103% scale if it's too tight.

File info

Longshot bolt handle.stl The replacement bolt handle itself. Bolt test fit.stl A file to test the fit on yours. Longshot bolt handle smooth.stl A replacement bolt handle but smooth if needed.

Print Settings

Supports:

No

Resolution:

Infill:

30%

Filament:

eSun PLA+

Fire Engine Red

Category: Sport & Outdoors